I assume you are trying to load 69xx-sip.9-3-3-2-sr1? If so, Download 69xx-sip.9-3-1-5 and try that. I ran into a similar issue with cucm 8.5.1 and send traces to Cisco, they should be validating the bug and releasing a new load at some point. Hope this helps. Sent from Cisco Technical Support iPhone App
... View more
Introduction I decided to upgrade a new Cisco AIR-LAP1142N-A-K9 from the factory lightweight image to an autonomous image so I can have a standalone AP in the event my WLC takes a dive. A buddy of mine asked me to post some instructions for him, so here it is. I completed this in just a few minutes, so this isn't a big deal. In my scenario, I pulled the 1142 straight out of the box and plugged the 1142 into a POE switch so DHCP to assign the 1142 an address so I could access it via my PC which is also my TFTP server for this exercise. I'm using PuTTY for serial access to the 1142 and SolarWinds TFTP Server. Procedure 1. Download your 1142 image from Cisco --- I chose c1140-k9w7-tar.124-21a.JY.tar 2. Copy your 1142 image to your TFTP folder and start your TFTP server 3. Hook up your console cable and open up PuTTY 4. Plug in your 1142 into your POE switch and ensure it'll get an IP 5. When it boots and your DHCP server gives it an IP address, you'll get a prompt (*your AP needs to get to your TFTP server) Use PuTTY and enter in the commands in bold and modify the address of your TFTP server and image accordingly. ap1111.1111.1111> ena Password: Cisco ap1111.1111.111# debug capwap console cli ap1111.1111.1111# archive download-sw /overwrite /force-reload tftp:// 10.0.0.10 / c1140-k9w7-tar.124-21a.JY.tar At this point, the 1142 is upgrading and it should reload in a minute or so with an autonomous image. Cheers!
... View more
This is a working config copied off a branch router (2851 running 12.4(24)T2 to avoid MGCP bugs in our environment and the CUCM is 7.1(2)). This is pretty raw but should compliment the rest of the guides in this forum for a working example. ! ccm-manager mgcp no ccm-manager fax protocol cisco ccm-manager music-on-hold ccm-manager config server 10.10.10.10 <--- Your CUCM Address ccm-manager config ! mgcp mgcp call-agent 10.10.10.10 2427 service-type mgcp version 0.1 <--- Your CUCM Address mgcp dtmf-relay voip codec all mode out-of-band mgcp modem passthrough voip mode nse mgcp package-capability rtp-package mgcp package-capability sst-package mgcp package-capability pre-package mgcp default-package mt-package no mgcp timer receive-rtcp mgcp sdp simple mgcp fax t38 inhibit mgcp fax t38 nsf 000000 no mgcp fax-relay sg3-to-g3 mgcp rtp payload-type g726r16 static mgcp bind control source-interface GigabitEthernet0/0.100 <--- Your Interface mgcp bind media source-interface GigabitEthernet0/0.100 <--- Your Interface ! mgcp profile default !
... View more
