Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have some users complaining about this error:Failed to install AnyConnect Secure Mobility Client 3.0.10057 because the process is running in protected mode and cannot perform an install. The secure gateway must be added to the Trusted Sites Zone i...
Hello,We have an ASA 5510 running in a DMZ that is the DMZ firewall for our wireless network. We have added a new VLAN to the network to accomodate more users on the wireless network. This new VLAN for some reason cannot receive IP addresses from ...
Connection events are the records of any connection that occurs on a monitored network. This can be an Access Control Policy, File Policy, IPS Policy, etc.An intrusion event is a subset of connection events that matches a configured Snort rule in th...
I used VLANs because I had a 12 port 2950 for L2 connectivity for the wired networks. I created a VLAN on the L2 switch for the wired network and a DGW of the wired network on the 881.I had a couple of sub-interfaces, one on Fa0/1 and one on Fa0/2. ...
Yes, I do route between my wired and wireless networks. The default gateway for both networks is my edge FW. I had a similar setup before I put Meraki in my house and it worked like this:881 was my CE2 networks10.0.0.0/24 for wired10.1.0.0/24 for w...
What you could do is put the Asus in AP mode where it will only act as an AP. I have an older Asus wi-fi router that allows for that configuration.You could then create a wireless network, a wired network, etc. and use the ZBF to control traffic bet...
