Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, Above all sorry for my English.I' m new in configure css and I have inerhited some of them configured and working. Now I need to change the balancing algorithm from aca to roundrobin. I tried with the command balance roundrobin -trying to...
Hi all,I need to know if there is a limit to the number of 35xx switch linked in uplink each other in order to obtain a redundant solution (I use a typical yellow cisco cable to create this). I listen that this number is limited to 8, but I haven't f...
Hi yves,Today I' ve experienced the same problem. I ' ve searched a lot all around but anyone gave me any ideas.I think it' s a problem in the configuration file. When I write "inservice" the configuration pass from active to standby (I've seen usi...
Thanks Mark,I' ve read the document time ago without finding the answer. Anyway just this morning I' ve found the answer:Before to change the balance you need to suspend the content, change the balancing and after active the content.I' m really disap...
