Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Sourav,Lets consider a new switch. all the ports belongs to the default vlan which is vlan 1.Native vlan is something that is defined on the trunk port.Lets say that SW1 --- SW2 and the link b/w these switches is trunk.when you dont configure anyt...
Well the way switch work is, lets say that the frame is coming out from a port which is in vlan 'x'.When the switches receives the frame on a trunk port, it finds out if that vlan 'x' is allowed on the trunk. if it is allowed, then it checks the nati...
Hi Sourav,sourav goyal wrote:Hi all,i am having a query for Native vlan concepts.i am using a default vlan001 in a multiple switches network. But on the trunks between all switches, have removed passage of all vlans. But just allowed another vlan 10 ...
Paul,What kind of cable that you use to connect between the switches? can you share the show int of the following ports.1. Port where the client is connected to.2. if the connection spans across switches can you share the interface output of both po...
Sorry I wasn't clear..I meant the Serial interface of the Switch should be configured with "ip nat inside" so that the traffic coming on this interface (typically I would assume it should be also be in private range) would also have to get natted .I'...
