Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
I'm trying to download ios for a cisco 2600 router from a tftp server. When the router is started it boots to rommon. I set the system variables ip_address, ip_subnet_mask, default_gateway, tftp_server, tftp_file and set confreg to 0x2102. start tftd...
No I have made no changes to the service module - figured if it works for one subinterface it should work for the others. As for the running config I gave it in the first post. But here' s the service module config. Thanks for the help.Module type is...
All of the circuits and DLCI's are correct and working. I have a production router in place and the network functions properly. I am trying to setup a router to have as a backup.
Here are the online test - Note the only subinterface that worked fails now because the serial line is down on the other end.(that is the provider has a problem at the remote router end) sorry.TestLab#sh ip int briefInterface IP-Addr...
