Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I try to make a QinQ tunnel between 2 routers (mikrotik and cisco). Between them there are 2 Aruba2930F.But from the Mikrotik, I can t ping the cisco and I don t know why.Here is the diagram of the labThis is the configuration of the Cisco : ! ...
Hi Giuseppe,To check this I connected my PC directly to the output of the switch with the same interface configuration as above.I ran a frame capture and saw that the packets were never encapsulated in vlan 1330.When I do port mirroring on the switch...
I try to just tag in Aruba. With port mirroring, I capture packet so the "encapsulation vlan" pingging but not the "encapsulated vlan"the config of cisco :int gi0/0.1330
encapsulation dot1q 1330
ip add 10.13.30.254 255.255.255.0
int gi0/0.1330100
en...
to be more precise, we currently have a fibre arrival for our customers with vlan as well as vlan in another vlan. On our switch we have :port trunk permit vlan X to Yand on the cisco we have all the interfaces for the vlan:interface GigabitEthernet0...
Hi Giuseppe,Thansk for your response.Actually we have a 3COM 4800 who let pass the qinq directly in the cisco. We need to change this 4800 with the Aruba.According to the documentation, the qinq on the Aruba is good.On the Cisco, vlan 10 is an extern...
