Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, i recently joined company and i found point that i want to clear out , our setup is like Cisco Switches enabled with Dot1x, MAB, Clear pass being used as AAA Server, my Question is that whenever i check any interface i don't see any authentic...
hello @MHM Cisco World ,please find below output as requested where only IP phone connected without PC.#sh authentication sessions int g 2/0/18 deNo sessions match supplied criteria.#sh mac address-table int gigabitEthernet 2/0/18 Mac Add...
Hello @Giuseppe Larosa & @MHM Cisco World ,appreciating your valuable feedback on this flow, so i believe @Giuseppe Larosa was right about host mode: multi-host this is the key point.two Action i have done:-A) i have replicate the same scenario on o...
Hello @bbb bbb , apologize for the late reply, i think the solution you are running for NAC with SNMP traps, we are running complete dot1x and MAB under the interface and we don't relay on SNMP trap to authenticate and Authorize the endpoints, your f...
Hello @MHM Cisco World Case 1,ip phone is connect without PC the AAA config to send back VLAN 15, domain is DATA or Voice in show authc session and the phone can work confirm above please Answer :in this case even though port is configured with 15 vl...
