Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two Cisco Catalyst 9500 Layer 3 Switch which are configured in and Active and Standby Hot configuaration.We are using these two switches as a top of the rack solution for a Proxmox / Netapps solution.When we do a normal upgrade on the two swi...
I am getting this message when using Kron Job completes itself sw1#sh kron scheduleKron Occurrence Scheduleback active, will run once in ERROR - Timer Not Runningsw1#sh kron scheduleKron Occurrence Schedule
SW#sh kron schKron Occurrence Scheduleback active, will run once in ERROR - Timer Not RunningSW#sh kron schKron Occurrence Schedule I am getting this issue when scheduling a simple kron job. Trying to back up the configuration on a switch. It is a ...
How do I schedule a Catalyst 9K upgrade using CLI Commands.I clicked y below at the switch restarted.POC-SWITCH#install activateinstall_activate: START Tue May 27 12:34:05 AEST 2025install_activate: Activating IMGFollowing packages shall be activated...
Still getting the errorback active, will run once in ERROR - Timer Not Running sw#sh clock10:37:24.311 AEST Thu Jun 5 2025sw#sh ntp statusClock is synchronized, stratum 5, reference is 10.31.80.22nominal freq is 250.0000 Hz, actual freq is 249....
Still getting the errorback active, will run once in ERROR - Timer Not Runningsw#sh clock10:37:24.311 AEST Thu Jun 5 2025sw#sh ntp statusClock is synchronized, stratum 5, reference is 10.31.80.22nominal freq is 250.0000 Hz, actual freq is 249.9970 Hz...
Sw1#sh ntp statusClock is synchronized, stratum 5, reference is 10.31.80.22nominal freq is 250.0000 Hz, actual freq is 249.9959 Hz, precision is 2**10ntp uptime is 2223542200 (1/100 of seconds), resolution is 4016reference time is EBEB4725.E3958378 (...
