Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone get SVI's to behave when using 64bit EIGRP metrics? I see this behavior on IOS-XE 16.9.5 and 17.9.5What I mean by this is, if you have a L2 port-channel, with 2 x 40g members this will "lose" in EIGRP delay calculation to a single routed ...
Thank you for the reply - this would work fine in the IDF situation, what is not shown in my diagram for simplicities sake is the many international links, with more than one hop that route via the Atlantic in some cases, not via the 9 foot fiber in ...
The delay command is set in tens of microseconds, and cannot go below 10 microseconds (1 being the lowest value that can be entered), irrespective of how it is displayed. Whether in named mode (displayed in pico) or original 32 bit mode (shown in mi...
Can you show me the section of the IOS-XE command guide that mentions delay and picoseconds? I am using named mode, and the "ip delay eigrp" command is not available as an interface level command. This works fine on NXOS, but not on IOS or IOS-XE. ...
yes this is what TAC also suggested, I want to steer away from this as we have a huge and complex EIGRP network, that we eventually want to move to BGP. I want deterministic, simple EIGRP before migrating sites.
