Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a setup where I need to run BFD on a static route, given below.R1 and R2 are ASR9K routers running IOS XR version 7.6.2N1 and N2 are components of a device that act as an L3 switch. The configs are similar on these devices.On R1, the bfd runs ...
Thanks for all the responses, they have been helpful.Unfortunately, I won't be able implement any of them since they would affect the existing bfd sessions.We have decided to change the design to use the existing primary IP for this link.
Hello Paulwon't this update the source IP for all bfd sessions?even if I configure the echo source ip under the interface, it will update the source for the primary IP also, right?I have a bfd running on the primary IP too, so that might get affected...
Hello Paul, thanks for your reply.Does that mean bfd on a secondary IP is not supported? Or is there any configuration to make the router use the secondary IP?
