Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi you guys!I need to put to work a firewall 515E on internet but I have two links with two diferent carriers, but I don´t know if it is possible.I need this links one for a farm server that need to go through and the another link for users and this ...
Guys! I need a Network managment system for LAN and WAN devices, about 100 (routers cisco, switches) and I would like to use What´s up gold edition. What solution do you recomend to use!CiscoWorks??Thanks
Hi guys! Some body knows how to enable ip routing in a Switch 6509 with CatOS.I tried to connect with the command "sessions" to the routing modulo but it said that the command is not supported.How can i check the status of the routing module?
Hi you guys!I have a Access Server but I need to configure NAT in order translate the IP addres from the asyncronus interfaces to an IP address that belongs to a local segment! the IP address are in a local pool into the router.The goal is if a user ...
I´m setting up a Access Server wiht Cisco 2612 with a 16-NM-AM and a Token Ring Interface. I were able to dial-in from remote location using windows dialup and getting an ip address from central site from the assigned DHCP Server (windows based). The...
So you think there is no Routing module in the switch?I did a telnet to Swtich and show this:macatalyst> (enable) session 15Module 15 is not installed.
it is not the module?Mod Sub-Type Sub-Model Sub-Serial Sub-Hw Sub-Sw --- ----------------------- ------------------- ----------- ------ ------ 1 L3 Switching Engine II WS-F6K-PFC2 SAL0752R6ZA 3.4
Here is the outputmacatalyst> (enable) sh moduleMod Slot Ports Module-Type Model Sub Status--- ---- ----- ------------------------- ------------------- --- --------1 1 2 1000BaseX Supervisor WS-X6K-SUP2-2GE ...
