Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
At the weekend I had an engineer take a look at our (basic) switch configuration with regards to an issue we were having when using failover on our firewalls. We had recently installed new switches and used the configuration of the existing switches ...
I recently replaced the cisco pix 515e we had running as a failover pair with a new 5506x pair. I have enabled the configuration as per the 515e setup as far as I am aware and it was working, for a bit. On the initial configuration, the active (calle...
Thanks.
The 2 ASA do use a direct connection from the failover.I am curious as to why it didnt work with the original configuration then, I am going to get someone to check the network cable for the ISL that is in VLAN2.
Should there be a need to ha...
Apologies for the late response, I had an engineer take a look at this over the weekend and the issue was with the switches and not the firewall. This has led me to having to ask another question on that, but consider this issue resolved.
Thanks fo...
This is something I am working with my ISP to resolve, I have since changed that IP to another (they told me the .43 was reserved for HRSP) yet I am not able to ping the external secondary IP from anywhere.
However, I would have assumed that even wit...
At present, the secondary is current disabled to ensure that the primary stays active, at least I know it works then. The config on the secondary is currently;
failoverfailover lan interface folink GigabitEthernet1/8failover link folink GigabitEthern...
