Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know which networks are selected by the harware client to be sent to the vpn headend device? Are the networks select from the static routes? or from the routes on the routing table (received via a routing protocol?)? is there a way to in...
I have a newly stablished VPN between a ASA 5510 and the VPN3030 concentrator. The session is successfully established, but traffic flows only from the ASA to the 3030 and never on the opposite direction. From the VPN3030 point of view, the Bytes R...
Hi, got into a dead end here. I have a pair of ASA firewalls running as active/standby. I'd like to use the 'failover exec' to issue commands on the standby firewall via the active one. This shouldn't be a problem, but we have AAA command authorizati...
I've found a couple of references on the documentation about this feature, often refered as TCP Multiplexing or TCP Offloading. But found no specific details on how it works or how to configure it.Does anyone have further datails about this feature, ...
I'm talking abotu an ezvpn setup where the headend has a dynamic crypto-map configured. Much like the one show here :http://www.cisco.com/en/US/docs/routers/access/1800/1841/software/configuration/guide/ezvpn.pdfDiogo
Hi guys, I have a very similar setup and am facing some issues with the backup peer.What I have is a Host ASA ->Link Load Balancer > Remote Routerthe remote router is configured with two peers. The first peers works great, SA is formed and traffic fl...
I believe its is a problem relate to the SQLNET fixup. I'm having a similar problem with the FWSM inspect for sqlnet. one solution would be to disable the fixup and permit all used ports for sqlnet. Not only the initial 1521, but all the ranga that i...
