Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a case where with C9200 switches we configured two REP edge no-Neighbour ports to connect a device that does not support REP as documented in figure 54 at this link interface GigabitEthernet1/0/2
description Link FROM CPU 2 ETH2
switchpo...
We have a case where with C9200 switches we configured two REP edge no-Neighbour ports to connect a device that does not support REP as documented in figure 54 at this link interface GigabitEthernet1/0/2
description Link FROM CPU 2 ETH2
switchpo...
basically we have a PLC supporting only STP connected to the switch with the REP protocol.Using the REP protocol in this way was the only way to make this redundant connection work
