About kevin.taylor

kevin.taylor · 03-18-2016

I am not sure what the issue is... I have my bios set to UEFI, I am mounting an ISO via CIMC virtual Media. Pick UEFI: Cisco vKVM-Mapped vDVD1.22 for the boot device.. When windows 2012 R2 setup loads and I get to the partition area I can not have...

kevin.taylor · 10-05-2018

In your case you need to clear the storage partitions on the hosts. You should follow this article to prepare a cluster for reinstall. Otherwise you will have all sorts of problems. Everything needs to be back to factory defaults (although you can...

kevin.taylor · 10-05-2018

So I was able to find a workaround for this nested vcenter issue before TAC could contact me. Proceed thru the install and put a fake vcenter cluster name as mentioned in the above BUG ID. When the install finishes you will not be able to login to...

kevin.taylor · 10-05-2018

I ran into the same exact issue as you. Received bug CSCvk07339 during install of hyperflex when trying an nested vcenter. Put a fake Vcenter cluster name in. Install went thru fine, cluster is online and healthy but I also receive "Cluster not cr...

kevin.taylor · 03-18-2016

I just like to say I resolved my own issue.... For whatever reason, and I did not see anything in the release notes, but I upgraded the server to version 2.0.9e from version 2.0.8d and it worked. I did the exact same steps as before.. nothing was ...

Member Since	‎03-18-2016 03:27 PM
Date Last Visited	‎10-12-2018 12:22 AM
Posts	5

User Statistics

User Activity

UCS C220 M4 UEFI Enabled Windows 2012 R2 Setup is always in MBR Mode

Re: hyperflex installation doesn't go thru

Re: hyperflex installation doesn't go thru

Re: hyperflex installation doesn't go thru

I just like to say I resolved