Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am using a Cisco RV110W (Firmware 1.2.09) in a branch and I would like to create a VPN Tunnel to another site that has a Cisco RV042 (firmware v4.2.1.02)What would be the correct Configuration??the current configuration I am using isin the RV042 ...
Thanks Diego for your answerI check the link, and is great to get started on VPNActually I have a couple VPN set in my RV042 Router and they work fineMy problem is matching and pairing the RV110W with RV042, to make the VPN Tunnel working between thi...
no, actually the tunnel is never establishedI have a post where I show the configuration I am using (in both side the RV042 and the RV110W)https://supportforums.cisco.com/message/3763284#3763284
The Internet Access Policyworked mediocre for me, It opnly work if I specify the optional client MAC address or IPBUT it only bliock http pages (port 80), if the client access the blocked site in https (port 443) it allow him to do it.so I was not ab...
I was trying to block Facebook, when I block the URL and specify the IP address of the client to block it work mediocre, becouse it only block http://www.facebook.com, but if the client type https://www.facebook.com it allow him to see the page.It o...
I have download the firmware 1.2.0.9 for the RV110Wand it does support GW to GW VPNI also have a RV042 in the other side, but I also was unable to connect them
