Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can convert one of my 1200 access points (firmware 12.02T) to IOS with the Wireless Lan Solution Engine (2.0) and configuration of AP is maintained. However, when I convert more than one AP at a time with WLSE, all APs are assigned the same IP add...
On several access points (14) in our environment the following messages are logged repeatedly:Stopped driver for port "awc0"Started driver for port "awc0"A reset of the config was recommended, but this did not solve the problem. Clients cannot authe...
Did you find out any more information on this? We have 100+ 1200 APs and this has happened to all of them, following an IOS upgrade! This happend once before and TAC got us to RMA the device, but since upgrading to 12.2(13)JA, this problem has star...
We have also been having a similar problem. Several APs are reporting "MALLOCFAIL: Memory allocation of 712 bytes failed from 0xFA428, alignment 0".Another AP was having memory problems, rebooted, and then would not reboot again. The AP would not c...
We were having a simliar problem with our 1200 APs. You can tweak: radius-server retransmit Xradius-server timeout Xcommands on the AP config. The default settings are 3 and 5. Apparently the AP only has 10 seconds to finish failing over to the se...
Thanks for the reply.I have attached a security template, following the documentation. There is nothing regarding IP info in it. Also, I tried the upgrade on 2 separate groups, both groups acquired an IP & hostname of one AP in their respective gro...
Thanks for your reply.We are using inline power for all APs. Some through the power injector and some through the 3524 PWA-XL. Only the 802.11b radio is being used. In the problem cases the cable is approx 150 feet. I can try replacing the power ...
