Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I installed ESXi 5.1 on an internal hard drive in a UCS C220 M3. I disconnected the media and then tried to boot, but it still can't find the OS. I went into the boot order and it doesn't even list the two internal hard drives. Anyone have a...
Hi All,I was working on setting up UCS blades servers today. There are two fabric interconnects. I connected them to the chassis using 4 links on each. For some reason only one of the io modules is showing up (io module 2). Any idea what could ca...
Sorry, I didn't get this until I had left for the day. However, I started reading up on it a bit. Apparently, it is the "embedded" controller (from the purchase order I have). Which I believe is what you're saying is not compatible with VMware. D...
I don't see either of them. It only says FlexFlash-0. Next to controller status it says "card not present." I don't have an SD card to put in, just the two internal drives.
1. This is the first time we've brought this up, so I don't know if the IOM has worked before.2. Yes3. Already tried4. Already tried. No matter which IOM is in which slot, IO Module 1 doesn't work.Thanks for your reply!
It's a 6248, and the IOM is 2280xp. The UCSM version is 2.0(3a).Cisco Nexus Operating System (NX-OS) SoftwareTAC support: http://www.cisco.com/tacCopyright (c) 2002-2012, Cisco Systems, Inc. All rights reserved.The copyrights to certain works contai...
