Hello, I want to enable netflow on my 6506-E core switch. The switch is the core switch for our HQ network serving 400+ people. I don't want any down time, can someone recommend the best way to do this with the lowest risk factor. Should I fol...
Hello, I am attempting to configure an ASA 5505 which is connected to 3 networks for access to an inside email server. Don't pay attention to the names on this config as they are not intuitive.The 3 vlans are:vlan 1 which has an IP of 192.168.x.1 - ...
Hello, any help or insight into why I can't get this working properly would be extremely helpful. I have a Cisco ASA 5510 connected to 2 private lans (1 for my HQ pc's{inside} and 1 for the worldwide mpls{outside}) It is also connected to the public ...
I have an ASA connected to:2 private LANS - 1 for my hq (where the asa physically resides) call this 10.1.1.0 vlan 1 - Interface inside security level 100 and 1 for the MPLS connection call this 10.1.2.1 vlan 2. - Interface Outside security level ...
I am attempting to install an asa 5510 at my hq. Our MPLS network is provided by our ISP and the routers are managed by them. They will be working with me to add the needed routes to the routers. Using version 8.4.1 That said, here is my challenge...
Ok but if the config is good then the server should be accessible even if I screwed up the packet-tracer. All other variables outside the firewall space are configured properly as the server works when I bypass the firewall. Seems 8.4.1 is seriousl...
Julio, I think we're old friends by now! Thank you for so much help.I thought I had it configured correctly as well. That is why I'm confusedas to why the server is unreachable via the proper URL. It is correctthere is only one lotus port need...
Ok, good.So I would configure the 5505 as I said with 3 interfaces:Inside (192) connected to dmz switchOutside (184) connected to internetMPLS (10) connected to core switch vlan dedicated to dmz traffic.Default route 0 0 184...Route mpls 10...Nat for...
Hi, I understand what you mean but I would be disconnecting the asa 5510from the public internet and from the dmz and replacing it with the 5505. Basically, just adding another firewall to the topology strictly for dmzpurposes.The problem before ...
Julio, I replied on the forums but my pic came out small. I'm trying to getyou a more readable version.Thanks again,-MikeOn Mon, Jan 9, 2012 at 12:57 PM, jcarvaja <
