About david

david · 07-13-2016

Dear Reader, I have 4 UCS C240 M4S running BIOS C240M4.2.0.9b.I upgraded one of them to C240M4.2.0.10e. But that also downgraded the Intel X540 network cards from 0x800004B5-1.446.2 to 0x800004B5-1.446.1Now I get the following message when I load Cen...

david · 07-28-2016

Hi Smittycsi, Yes I got it working.I have 2 cards in my system so from the BOIS is disabled one.Then I used the flash utility again and flashed the same ( lower ) version again. After this the card start working normally .. then I enabled the second ...

david · 07-14-2016

Hi Kirk, Thank you for your reply. I found something else.Before the interfaces where named enp2s0f0, enp2s0f1, enp6s0f0 and enp6s0f1.Now i only have enp2s0 and enp6s0.They are working though but only as a single port.I didn't change anything to Linu...

david · 07-14-2016

Dear Walter, These are standalone server. And they came with the Intel X540 factory installed. But the X540 is not in the support matrix. I am running the 64 bits version. I got the cards up by enabling the optionROM but they only show 1 port per car...

Member Since	‎07-13-2016 02:46 PM
Date Last Visited	‎03-28-2018 12:09 AM
Posts	4
Total Helpful Votes Received	15

User Statistics

User Activity

Intel X540 10GBase-T EEPROM Checksum Is Not Valid

Hi Smittycsi,

Hi Kirk,

Dear Walter,