Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all,I have a server on a network off a FWSM that's playing out video using multicast. If I have a PC on the same network I can connect using the muticast address and port number using UDP and it works. I then enabled 'multicast routing' on the ...
Hey guys,I have two 6500's with FWSM's. The 6500's have a VPN connection from each to a PIX for VPN between two sites. The route out of the FWSM is the HSRP of the two 6500's so while both connections are up there's no problem. However, if one VPN...
Hi guys,I wonder if anyone has tried this senario before and could let me know how to get it to work!I have a pair of 7100 routers that I'm going to use as VPN termination points on our network. The routers run HSRP across the F0/0 interface to achi...
Morning all,I wonder if anyone has seen this problem before and knows what the issue is:I've set up an site-site VPN between a 6503 and a 2600 internally, to mock what's going to happen when the 6503's move to a seperate site. The tunnel comes up ok...
Hey guys,I'm configuring a FWSM with 3.1(6) and need some help regarding NAT on the outside interface.I'd like to know if it's possible to use nat-exemption on the outside interface without using a static as I'll be using the statics to translate fro...
Ok, I managed to get this working!I set the FW with the receivers to be the opposite of the source one so on the VLAN with the receivers in it I set the igmp-forward interface outsideOn all the 6500 links and VLANs up to the FWSM's I enabled pim usi...
Have had some success...I can now see the video if I put my receiver on a VLAN on the 6500 that has the Source's FWSM in it (the VLAN isn't part of the FWSM and is directly on the switch). So my config for the FWSM would appear ok now. It's igmp-f...
I have attempted to make the 6500 with the FWSM with the source attached as the RP (using it's loopback address).From the FWSM:interface Vlan120 nameif outside security-level 0 ip address 10.1.120.1 255.255.255.0 igmp forward interface ltmisc -- W...
Yes, on the FWSM with the source attached I have:"igmp forward interface outside" -- but have also tried on interface outside "igmp forward interface "sourceinterface" -- which is correct?I also have "multicast-routing" on but have added no mroutes o...
