About ianwardGD

ianwardGD · 06-16-2011

Greetings,I have a 4506 with a SUP7-E acting as a core in a hub and spoke topology. My customer got the core with only the LANBASE license. He needs to implement basic Mulitcast functionality such as:router eigrp XXnetwork x.x.x.xvlan10ip pim dense-m...

ianwardGD · 04-25-2011

I have set up two switches connected to each other with a basic configuration. On one switch the Loopback address is specified as 10.10.10.2 255.255.255.255 and the other Loopback address as 10.10.10.254 255.255.255.255. I am unable to ping the Lo0 o...

ianwardGD · 04-15-2011

Greetings,I have a c3560-E and I am trying to copy a startup-config from an FTP server which is directly connected on gi0/1 to the switch. When i enter the command "copy ftp: startup-config" and give the IP address and filename it gives me an error "...

ianwardGD · 03-22-2011

Greetings,I have been tasked to prove that clients in separate access Vlans cannot get to each other whatsoever. I have three switches connected in a tree, with the core having different EIGRP AS numbers for each VLAN. The core connects the two other...

ianwardGD · 04-26-2011

So I added the loopback addresses to the network's EIGRP AS and they were able to ping each other. My question is what if I don't have a common network that the Loopback addresses can use to route around the network. Is there a way to create a sepera...

ianwardGD · 03-24-2011

there is no VTP enabled here, since this was a test set up, adding management IPs for each VLAN on the edge switch was an easy way to make sure there was connectivity between the switches and the correct VLANs were being trunked to where they were su...

ianwardGD · 03-23-2011

I did not specify the default gateway on the two clients and once I did the pings went through successfully. I'm a little confused as to why the pings were successful as I thought there needed to be on a common routing protocol(AS). Am I correct in t...

ianwardGD · 03-23-2011

Here is some relevent configs for the 3 switches:CORE:interface TenGigabitEthernet1/1 switchport trunk allowed vlan 10,15 switchport mode trunk!interface TenGigabitEthernet1/2 switchport trunk allowed vlan 10,15 switchport mode trunk!!interface Vlan1...

Member Since	‎03-22-2011 01:20 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	8

User Statistics

User Activity

SUP 7-E License

Loopback addresses unable to ping each other(SVIs or Lo for MGMT?)

Copy startup-Config to Switch without Layer3?

How to prove no inter-vlan Routing

Re: Loopback addresses unable to ping each other(SVIs or Lo for

Re: How to prove no inter-vlan Routing

Re: How to prove no inter-vlan Routing

Re: How to prove no inter-vlan Routing