Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear allI am facing a problem a strange problem with the ACS. I am using 802.1x on my network to authenticate the users. I found that when I connect my network cable and put my credentials the authentication will fail directly. I will disable my conn...
Dear allI have ACS 5.1 and Catalyst switch 3560 with version 12.2(53)SE. I configure a dacl on the ACS and I use it on authorization profile.This authrization profile is used on access policy. I tried the authentication but it doesn't work. I checked...
Dear AllI have configured the 802.1x with PEAP auth. on my LAN with ACS 4.1.ACS 5.x is there now, What the enhancement and features added to the ACS 5.x related to 80.2.1xPlease advise in details because we need to buy the ACS 5.x if it has enhanceme...
Dear AllI am doing a migration from pix 6.3 to ASA 8.3 and I have the following nat configuration:Pre 8.3interface GigabitEthernet0/0 nameif outside security-level 0 ip address 10.50.50.249 255.255.255.0 standby 10.50.50.250 !interface GigabitEtherne...
Dear AllI have two ASA 5520 with 4 Giga interfaces and 1 management interface.I need to use 4 interfaces four data traffic1- Inside2- Outside3- dmz-14- dmz-2The remaining will be the management interface only.How can I configure the Statefull failove...
Dear VciricThe critical vlan is applied when the radius servers are down and you are trying with a new authentication i.e. if the user was already authorized he will not be requested to authenticate again till the 802.1x timed out on the switch port....
Dear NicolasI faced the same issue again but with different scenario.I am doing machine authentication plus the normal authentication. I have standard policies to force the machine to be authenticated for all groups and I have an exception policy for...
