how can i manage a remote firewall configured with a site-site vpn? Site A and site B have a site vpn. I am site A and would like to telnet into site B to change some ACL's but can not get into it.
I have 2 5510's in active/standby. The primary will run fine for about an hour and then the unit will stop passing traffic. I have to force the standby unit to be active. The outside interface on the failed unit shows (waiting). I can ping the ou...
I have two 5510's and I am using the management port for the lan failover. Just remove the management-only command from the interface and you can use this port like any other. I am sure some more experienced users here can elaborate.