Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having telnet issue. I CAN connect to the router either from con 0 or a telnet session. However, I cannot copy the running-config of the router to my pc on the lan using tftp. This started after I enabled aaa. I have tried several attempts at mo...
Router is a C1720 with FW/IDS feature set 12.2(17)On a LAN workstation I loaded and configured KIWI-syslog server.(192.168.222.61)On the router I setup the Post Office to send syslog messages to the syslog server(my pc).I have reloaded the router twi...
I have a 1720 router that I need to configure IPSEC, PAT, ESP, passthrough.I have been searching CISCO on and off for months.I am using a Symantec Enterprise VPN client trying to get access to my clients Symantec Firewall.I can get connected to the r...
I purchased the PIX 501 for my home broadband connection. Prior to installing it, I am trying to learn it at work.I can't get ethernet0 to accept a DHCP assigned ip. Probably something simple.Should I be using a crossover or straight through cable ?
As a follow-up...tftp is working on my workstation. From another workstation, I transfered a file from my workstion to the other workstation.Using ethereal, I captured packets during a console session into the router. ICMP echo/echo-replies were capu...
Clarification to my issue.Network setup:The 1720 router is a office gateway router. It's the only router.It is physically mounted in my office.e0 has two interfaces. One public, One private (192.168.222.1)My workstation is 192.168.222.61My workstion ...
kidem, Your access-list needs some help. without know what your particular access needs are, it's hard to say what needs to be fixed.However, I am using a 1721 myself AND am going through the same thing...tweaking the security. I have found two refer...
Confused was an understatement. Upon initial configuration, I didn't understand why I needed it in the first place. The configuration came from CISCO CCO doc's.Anyway, took out: ip audit po....Changed running-config:#logging trap debugging#logging so...
