Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I have one PIX 506e, on inside lan there is one PC client, on this client there is SSH Sentinel VPN Client software for connect this PC to a Remote lan protected by Zyxel Router/firewall. When I activate Sentinel software, VPN Tunnel goes ON ...
Hi all,I have one PIX 506e, on inside lan there is one PC client, on this client there is SSH Sentinel VPN Client software for connect this PC to a Remote lan protected by Zyxel Router/firewall.When I activate Sentinel software,VPN Tunnel goes ON but...
Hi all,I have one Cisco PIX 501 connect by outside interface to a Telecom Router. This Router show his state by web page. The router automatically each 5 minutes updates his tables and publish IP Addresses of each host connected, on his web page.I th...
Hi all,I need support.I use Cisco Vpn Client Ver.4.06, I select "Allow local LAN Access" but only traffic directed to remote LAN is permitted.Ho to improve split-tunnell?Where can I find any example?Tks all.
Hi all,I need to improve Public Network Site To Site VPN with two Pix-506e but LAN1 and LAN2 have the same Private Network Address:192.168.1.0 255.255.255.0 Is possible to realize this VPN???Tks all.
Perhaps now I have understood:1) Remove: isakmp enable outside command2) Add: fixup protocol esp-ike command3) Add: isakmp enable outside Is right now?
Thank you for patient and support...I try the command: no isakmp nat-traversal, after this I try conection by Zyxel Remote Security Client but the problem is the same...
Thank you for answer,the command: no isakmp nat-traversal Workswile the command: PIX(config)# fixup protocol esp-ike return this:PAT for ESP cannot be enabled since ISAKMP is enabled. Please correct your configuration and re-issue the command!
This is configuration on my PIX: PIX Version 6.3(5) interface ethernet0 auto interface ethernet1 auto nameif ethernet0 outside security0 nameif ethernet1 inside security100 hostname PIX domain-name intranet.luceat.it fixup protocol dns maximum-length...
