Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can someone please tell me the full ip ranges that are blocked by enabling anti-spoofing on an interface.I am expecting it to be 0.0.0.0/8, 10.0.0.0/8, 169.254.0.0/16, 172.16.0.0/12, 192.168.0.0/16. RegardsRichard
When you use the clear ip bgp x.x.x.x command after changing BGP timers, how long would the service interuption be?I done the clear ip bgp x.x.x.x command on a test router with three external bgp neighbors.( one neighbor at a time), and I see from th...
bgp fast-external-fallover is supposed to be enabled on Cisco IOS by default.If in the config you do not see "bgp fast-external-fallover" under router bgp 12345 does that mean it is enabled?Router is running12.4(12)
Getting the following 733100 events, and all are ScanningASA-4-733100: [ Scanning] drop rate-1 exceeded. Current burst rate is 10 per second, max configured rate is 400; Current average rate is 56 per second, max configured rate is 200; Cumulative to...
Hi PeterMany thanks for response.I tried various soft commands, they did not show they timers had changed.My routers do not have a large routing table or prefixes, so would you say a sub one minute outage is a conservative estimate.Regards
I had a simular issue on a 4240, could never see the traffic for 198.133.219.243, had firewall open etc.What fixed it for me was at my firewall, going from a static NAT rule for the appliance to a dynamic rule for inside network to outside interface.
