Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Catalyst 2950 - 24 port switch and it is connected to a Cisco 2620 router. When I am on the 2620 and type show CDP neighbour I can see the 2950 switch, then I console onto the switch and type show CDP neighbour I am unable to see the router....
sh int f0/1FastEthernet0/1 is up, line protocol is up Hardware is Fast Ethernet, address is 000c.ce2d.6d01 (bia 000c.ce2d.6d01) MTU 1500 bytes, BW 100000 Kbit, DLY 1000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA...
h int f0/0 FastEthernet0/0 is up, line protocol is up Hardware is AmdFE, address is 00d0.bbd3.26c0 (bia 00d0.bbd3.26c0) MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopbac...
Move to a different switch port same result. Unable to move to different router only one available. I have just tried attaching a 1750 router to the switch and it works ok, could it be an IOS problem with the 2620 router? Current IOS on 2620 flas...
