Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have few WLC having configured as :
%IP_SNMP-4-NOTRAPIP: SNMP trap source GigabitEthernet0 has no ip address errors on WLC logging and it was working fine before, actually there are similar WLC with same config are also working fine.
I have configu...
MY issue has been resolved after deleting and re-adding both the controllers from DMZ(AireOS) and 9800(IOS-XE) Controller and before deleting mobility peers from 9800 controller, it is required to to move the anchor controller from Policy Tab and re-...
I am having the same issues and DMZ controller send keepalive messages to 9800 controller and when i check logging on 9800 Controller the peer link to DMZ is down.on DMZ:*mmMobility: Jun 20 11:33:17.758: Keepalive:VALID:ETHOIP_OP_REQ:Sent to 10.xxx.x...
I am having the same issues and DMZ controller send keepalive messages to 9800 controller and when i check logging on 9800 Controller the peer link to DMZ is down.on DMZ:*mmMobility: Jun 20 11:33:17.758: Keepalive:VALID:ETHOIP_OP_REQ:Sent to 10.xxx.x...
