Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I'm facing some challenges while configuring Posture with closed mode and an IBNS 2 setup.First, is it possible to perform posture checks in closed mode?How did you manage port configuration and ACL/DACL settings?Should the ACL be used fo...
I did some digging, and it turns out that simply enabling "stateless authentication resume" causes this issue.It's quite strange and have simply removed this option.(ISE issues TLS client a session ticket that can be presented to any PSN to shortcut...
After some troubleshooting, I discovered that my laptop was making two authentication requests during a cold boot. Although both requests used the same RADIUS username, the identities in the logs were different—one was hostname@domain.com and the oth...
Authentication is successful, but the workstation can't send its posture to ISE.I get the error: "Cisco ISE unable to detect AnyConnect posture agent." on the workstationStrangely, everything works fine after a shut/no shut action on the port. Howeve...
Everything works well, especially when I disconnect the cable.The ACL, web browser pop-up, and all checks confirm that everything is functioning correctly.However, the main issue arises when I start the PC.In this situation, the automatic check does ...
