Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have taking over this gear from previous admin. we want to upgrade versions to the latest.we have: Cisco 4402 ver.4.0.179.11 50 ap supportCisco 2700 ver.2.0.31.0WCS ver.3.2.40.0I have installed WCS ver. 4.1.83.0 and restored that old DB on new se...
Hi I have question regards to Cisco WLAN production. We just purchased couple of Cisco Aironet 1000 AP (AIR-AP1030-A-K9), Power injector for 1000 series (AIR-PWRINJ-1000AF) and a Wireless LAN Controller Mode 4402. We try to setup the Aironet 1000 b...
Hi, Currently I am using asa 5520 with PIX 7.0(2). I experience asdm problem. When I asdm into asa firewall it shows "the number of asdm session has exceeded 5" Try console in and run serveral time of "asdm disconnect 0 and to 4" both in privilege...
Hi I have question about ASA firewall. I have ASA 5520 (ASA PIX v7.0(2)) with SSM-20 (IPS v5.0(2)) module installed. The gigabitethernet0/0 is named as Outside, and gigabitethernet0/1 is named as Inside for ASA5520. Also in the ASA I enable inline ...
Hi, I just got my ASA 5520 firewall with (ASA SSM-20 module) couple weeks ago, and I am trying to configure IPS features but I getting this problem:This is output from CLI:-------------Asa5520fw# session 1Opening command session with slot 1.Connected...
Thanks! It works; I am getting more outside logs now. Also is there any a client tool or IEV for IPS v.5 available? Or only able to view through ASDM IPS?Thanks,N
Thanks for promptly reply. Almost all of events logs in the SSM are showing with my Inside IP address as source address.Such as: participants: attacker: addr: 10.2.11.28 locality=OUT port: 1233 target: addr: 216.1...
