Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently upgraded our DCNM server to 6.3(1) and we've noticed that the server hosting the DCNM application is doing more IOPS than any server in our environment!It seems to be doing 8,000 - 10,000 IOPS constantly.In Windows you can see that postgr...
We've installed Windows 2008 R2 on a couple of B200 M2 blades.Each of them is showing a "Removable Disk" in Windows Explorer. (See attachment 1)When you go to Disk Management and go to the properties of the disk (usually disk 1) it says the type of ...
Just finished connecting our 4th chassis and it is showing the following error: "right IOM 4/2 (B) POST Failure"Attached is a screenshot of what I see in UCS Manager under Chassis 4 Faults and POST Results on the General tab for Chassis 4.Any ideas o...
We are setting up a test pair of of 6120's and are trying to get the uplinks going. We are only doing a single uplink from each fabric interconnect.So fabric interconnect 1 goes to 5k-1 and fabric interconnect 2 goes to 5k-2.Since we are only doing ...
Is it possible to create a KVM role in UCS Manager?We are using LDAP for authentication and we'd like to map a group to a role that would only allow KVM access. The users in the KVM role would be able to see a remote console, power the server on/off,...
Thank you Robert, resetting the IOM fixed the issue.Went to Equipment, Chassis, Chassis 4, IO Modules, IO Module 2, then clicked Reset IO Module and after about 5 minutes the error went away.Thanks for your helpful response!
Thank you, the "service-profile-ext-access" role was what I was looking for. I had a hard time figuring out what rights the different roles give you.But it looks like that allows you to do KVM.Thanks again for your help!
