Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have just been having a go at setting up an 801 ISDN router to connect to my ISP. I have used FastStep to do this.It initially seemed to work a treat. I can browse the Internet from a PC connected to the same network via the router, then after a ve...
Let me start by saying that I am very inexperienced with Cisco routers. I have two remote users (Howard and Gary - me) who dial into our central site which has an 801 ISDN router. Originally, one remote user had a 761 router and the other an 801. A c...
I'm quite new to the 801 ISDN router and network management. I would like to be able to get information from my router about connections. I am using HP TopTools as my network management software (it was free with some switches that I bought). I did a...
Hi Georg,Thanks for the reply. I had a go at removing the ppp multilink settings out of the dialer and BRI 0, as well as the dialer load-threshold statement and it worked OK. It didn't try to bring up a second line and the connection stayed up. I'll ...
Hi Mark,I managed to try the connection out last night and it worked fine - many thanks.One thing that was a bit puzzling though was that Howard also dialled in last night; he tried it with his new notebook and whilst he managed to get in with IP add...
Thanks for the reply Mark. I'll give your suggestion a go. I probably won't get the opportunity for a few days, but will get back to you when I've tried it.Thanks again,Gary
When I got the previous message, it stopped it from loading the MIB.Also, the above link prompts me for a username & password (which I don't have).Thanks,Gary
When I try to load most of the MIBs listed in the document that you reference, I get:"This MIB module does not contain trap definitions"BTW, I'm using HP TopTools 5.6Thanks,Gary
