Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our client recently purchased a Network Advantage license to upgrade an existing IE3300 switch from Network Essentials. They need this to enable EIGRP routing functionality. I ran through the license reservation upgrade procedures from the Cisco docu...
Me too. Hopefully this post can help someone else someday.Unfortunately, the switch is no longer on my desk, so I cannot currently run commands to validate whether smart licensing is enabled. I can tell you that some of the commands used for this pro...
Thank you for the response.The procedures I linked above did work to 1) request, 2) reserve, then 3) install. However, functionality of Network Advantage did not follow, and nothing seems to be documented in this set of info for next steps.Show Licen...
Hi lacemi, I was also originally trying to use install mode (boot sys sdflash:packages.conf), which is what ran me into all of these difficult behaviors you're describing. With that note about swap drive only working with bundle mode, I'm forced to c...
Hi lacemi,Thanks for sharing your detailed analysis. I also experimented with a swapped SD card on a defaulted switch at an older firmware revision trying several variations, effectively following a process of elimination. What finally worked was hav...
I was just misled by the IE3x00 System Management chapter on SD Swap Drive. Thankfully, I found this forum explaining what's going on. Can you provide an update on when accurate documentation will be released?
