Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've setup Remote Access VPN on FTD 1120 using FDM method. I've used the following link to configure the firewall. https://www.cisco.com/c/en/us/support/docs/network-management/remote-access/212424-anyconnect-remote-access-vpn-configurati.htmlThe iss...
I'm working on configuring the Cisco AP 9115-axe as embedded wireless controller. So far I've changed the AP to EWC mode and configured the hostname, IP and route. AP is connected to Cisco 9200 switch running version 17.9.4a, EWC is running version 1...
Hello, The output of the commands you listed above: Protocol Socket State Local Address Foreign AddressSSL 000052f8 LISTEN XXX.XXX.XXX.XXX:443 0.0.0.0:*DTLS 008037f8 LISTEN XXX.XXX.XXX.XXX:443 0.0.0.0:*> show running-config webvpnwebvpnenable outside...
I still haven't been able to figure out this issue and was hoping that someone out there has come across this. I would appreciate ton if anyone could help and give me some clues. Thank You.Regards,S
Is there a device in front of the FTD that could block ICMP or SSL/IPSec? - Just Comcast modem. Can you ping from the FTD CLI to the internet?- Yes I can ping the ISP connection from the FTD CLI. Is routing setup correctly via the outside interface? ...
Initially I was assigning the IP statically to EWC. After going through the link provided gave me an idea to get an IP address through DHCP, so I enabled DHCP on the management VLAN. That gave me an IP address for EWC and an AP which worked just fine...
