Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So you were able to add it to WCS, but you get an Audit Status as Not Available? I think this is due to the Configuration Sync task has not ran yet since the device was installed. Check Administration>Background Tasks>Configuration Sync for when th...
Revised:5GHzTx Power Num Of Supported Power Levels ............. 8 Tx Power Level 1 .......................... 17 dBm Tx Power Level 2 .......................... 15 dBm Tx Power Level 3 .......................... 14 dBm Tx Po...
from command line: show run-configTx Power Num Of Supported Power Levels ............. 8 Tx Power Level 1 .......................... 20 dBm Tx Power Level 2 .......................... 17 dBm Tx Power Level 3 .........................
