Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Spanning tree question, I have layer 3 switches connected via fiber in geographically different locations. These sites are connected via switchport mode access and the VLAN associated with the SVI that is being used for the layer 3 traffic. I have ...
I just ran across this and I know its old. But a quicker way possibly to see if port fast is enabled on an interface can be accomplished by this command.
SW1#sh spanning-tree int g1/0/1 portfast VLAN0010 enabledSW1#
If it is done on a non portfast p...
