Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to use the catalyst/DNA center API to pull the power usage of our wireless access points but having gone through it several times I cant seem to find it. there is a large number of them so Ideally looking for one where I can get default 100 or...
Thank you Gabriel for your support. I was looking into using the command runner feature to run these commands "show ap dot11 5ghz sum" and then again for 2.4ghz on the wireless controller, as that would return the power usage. Is this what you are re...
if you use a UTC time of about 6 minutes ago and that will filter a lot of the disconnected out and then you can are always just filter the last few out at your end.
