As networks created after August 1, 2025 require to have mandatory passwords set for Local Status Page access, I would like to know if there is any API call to push a LSP password for all or several networks.I did not find any to push the LSP passwor...
Forum Posts
Hello everyone,I am currently trying to reproduce the Firmware status widget from the Meraki Dashboard via API.Dashboard example:Warning: 20 networksCritical: 16 networksHowever, I cannot find the actual Dashboard firmware lifecycle status in any API...
Hi everyone,I’ve been exploring Workflows for Automation in the Meraki dashboard and would love to hear how others are using it in real-world environments.For those who’ve deployed it, what practical use cases has it been most valuable for? Are you l...
We are planning on upgrading our ISE RADIUS server, the IP address will change.I am aware of following API call to change the RADIUS server for a SSID /networks/{networkId}/wireless/ssids/{number}My question is, can the above API call just change the...
Hello, everyone!This is my first post in any Cisco community, so please bear with me and feel free to redirect me if needed. I'm a novice-intermediate Python programmer and this is my first real use of it in an enterprise environment.A little backgro...
I'm able to reach other end-points OK, but this end-point is returning a 404 error.(I have opened a case with support about this as well and will update this forum thread when I hear from them.)
Hi Everyone.Hope this is in the right section, first post since things were merged.I need to cleanup our webhook receiver list that is located under Organization - Monitor - Alerts. All I can find is articles on how to clean then up under Organizatio...
Hello friends! If you're attending Red Hat Summit, be sure to check out our breakout session on May 13: "Optimize your network operations with Red Hat and Cisco". Our very own @shwpalan will be showcasing how Cisco and Red Hat Ansible Automation Plat...
Resolved! oamp API
Hello!Where can I find documentation for this API: https://<oamp-server>:9443/oamp/api/v1/ For example, here it is # Отримати статистику кампанії 1001 curl -X GET \ "https://ucce-oamp.internal:9443/oamp/api/v1/campaigns/1001/statistics" \ -H "...
Hello API enthusiasts! Postman collection for Cisco Catalyst Center v3.1.3 is now available here - https://www.postman.com/cisco/cisco-dna-center/collection/v0sdamd/cisco-catalyst-center-api-3-1-3?action=share&source=copy-link&creator=53853750You can...
Hi everyone,I’m currently trying to retrieve the configuration shown under Security & SD-WAN → Threat Protection → Trusted Traffic Exclusions via the Meraki Dashboard API.Specifically, I’m looking for a way to access:Trusted Applications (e.g., Softw...
I am trying to pull the clients that where seen the day before. When i specify t0 , the call returns 400 Bad Header. here is the example URI i am trying to use https://api.meraki.com/api/v1/networks/#############/clients?t0=2026-04-13T05:00:00.000000...
Hello Cisco Meraki Community,I’m looking to better understand whether the Cisco Catalyst access points CW9162 and CW9172, when managed through the Meraki Dashboard, expose the same set of Meraki Dashboard API objects as native Meraki MR access points...
We recently purchased over 2,000 Meraki access points and created approximately 50 school networks. Each network requires the assignment of 40–80 APs. However, we have encountered a significant challenge: the current Meraki dashboard only allows us t...
Resolved! Dashboard API Usage units kb or MB
I’m using the Meraki Dashboard API endpoint:GET /organizations/{organizationId}/clients/overviewThe response docs suggest the usage totals are in kb, but when I compare the API values to the Meraki daily summary email, the values appear to line up mu...
