Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would appreciate your support on the following LABI have one Router VXR1 connected to 2 routers: ISP1/ISP2.R1 is always using ISP2, even though ISP1 is reachable. ping from R1 to 8.8.8.8 using source interface F0/0 isn't reachable when the track is...
Hi dear,i did configure the ip route using the next hop IP Addr but it dosen't make any diffrence since the interface that gets down is the L0 of ISP1 and no the next hop interface.thank you for your feedback.
I did sir but it didn't solve my issue.inserting a root towards the 8.8.8.8 will make my configuration like this : !ip route 0.0.0.0 0.0.0.0 FastEthernet0/0 track 1ip route 0.0.0.0 0.0.0.0 FastEthernet1/0 10ip route 8.8.8.8 255.255.255.255 FastEther...
Another Update : when the Loo0 of ISP1 is Down, the traffic is sent to ISP2 and the ping is reachable. but once the ISP1 is UP again, the traffic isn't going back to ISP1.
Hi dear,VXR1#ping 8.8.8.8 Source f0/0Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds:Packet sent with a source address of 10.1.11.1.....Success rate is 0 percent (0/5)VXR1#show ip sla statistics 1 details...
Dear;When I do this : VXR1(config)#no ip route 0.0.0.0 0.0.0.0 FastEthernet0/0 track 1VXR1(config)#ip route 0.0.0.0 0.0.0.0 FastEthernet0/0VXR1(config)#do show ip routeGateway of last resort is 0.0.0.0 to network 0.0.0.0S* 0.0.0.0/0 is directly conne...
