Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I purchased a new Access Point Cisco Catalyst 9162I. I want to set different channels so that my devices could get connected to that and receive data from different channels simultaneously how do i achieve this. Regards.Pranav Ghabade.
Hi Sanandy,Appreciate the suggestion! Setting up two SSIDs on 2.4 GHz and 5 GHz makes a lot of sense for my use case. I’ll give that a try. Thanks again!
Hi Scott,Thanks for the clarification! I had misunderstood how transmit and receive work your explanation about half-duplex operation and same-channel usage really helped clear that up.
I want it for my research project. the Access Point has multiple channels. i just want to do is the want to set different SSIDs with different channel settings. for that i created the different SSID. Then in RF settings i tried to create a new profil...
No, what i want is channel separation for load balancing and interference avoidance.The explanation talks more about channel width (20 vs 40 MHz) — which is about how wide a channel is, not about using many different ones
didn't understood the solution you are saying. want a detailed solutions or steps how to configure multiple channels on AP so that devices could connect to it. If anyone can help. I want to have multiple channels so that each receiver should get to r...
