Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,
Looking for some design suggestion and the configuration steps on ACI.
As per my requirement traffic originating from Internal EPG(vlan 10, 20 ,30) it has to pass through firewall and it has to go internet via l3out. if the firewall down tr...
Hi @summerSunshine ,
The new APICs must run the exact same software version as the existing APICNode IDs must match the previously vacated vAPICs slots (typically nodes 2 and 3)
1. Match Software Version On your new physical APICs:Install the exact s...
hi @Portus92 ,
as per the released date Recommended version as per release notes is 4.3.6. but due the bug Cisco Software Advisory Notice for CSCwo74485. which will make the apic not bootable. so apply the workaround and proceed with upgrade.
Hi @Monsinka
Use Preferred Group if Your goal is "free communication between EPGs with traffic control enforced only on the firewall."
or
Consider Unenforced VRF Instead: If all EPGs in the VRF should communicate freely without any ACI policies (mir...
Hi @grandhipavan41 ,
In Cisco ACI, it is possible and common to connect multiple physical uplinks (such as 2x100G links) from a single leaf switch to the same spine switch. This is a supported design choice to increase bandwidth and provide redundanc...
