About Portus92

Portus92 · 10-09-2026

Hello,We are experiencing a multicast RPF convergence issue with Cisco FTD 7.6.4 connected to a Cisco ACI fabric.Topology:Two FTD firewalls configured in Active/Standby HA (FTD A is active).Both firewalls are connected to the ACI fabric through port-...

Portus92 · 04-21-2026

Hi,We would like to activate telemetry services in Nexus Dashboard to monitor our ACI fabric bandwith usage, etc.We setup a new Nexus Dashboard VM (VMWare) with 1 node (32vCPU, 128Gb RAM, 1 HDD with 50Gb and another one with 3Tb), but we have only to...

Portus92 · 03-13-2026

Hi,Quick question regarding the APIC Simulator and a production ACI environment.I would like to deploy the APIC Simulator as a VM in our virtualization cluster, which is connected to a production Cisco ACI fabric. My understanding is that the simulat...

Portus92 · 01-29-2026

Hello,I would like to understand Cisco’s recommended procedure for upgrading the CIMC firmware on an APIC L4 cluster.Current setup:APIC model: L4APIC version: 6.0(8f)CIMC version: 4.3(4.241063)Cluster size: 3 APICsTarget versions:CIMC: 4.3(6.250053)A...

Portus92 · 03-04-2022

Hi,Is it possible to automatically set the agents back to ready state in Finesse when the jabber is back up and running after a "phone failure"?If not, is there a way to alert the agents that they are in a "not ready" state?We have UCCX in version 11...

Portus92 · 05-20-2026

Hi,Yes, we did, but we upgraded the APIC first because of this field notice: CSCwo74485 Upgrading the CIMC first is still our preferred approach, but I think you can also upgrade it afterward, as long as the current CIMC version is supported by the t...

Portus92 · 03-25-2026

Thank you, it helps me a lot!

Portus92 · 02-20-2026

Hi,Does this mean I can choose between upgrading the APICs first and then the CIMC, or applying the workaround (ISO file) so that I can upgrade the CIMC first and then the APICs?

Portus92 · 07-25-2020

Thank you !The config on RemoteLab is now : crypto map staticMap 5 ipsec-isakmp set peer AB.CD.160.216 set transform-set P2PSET match address 150 crypto map staticMap 10 ipsec-isakmp dynamic dynamicVPNAn I changed the tunnel mode on both : crypto ...

Portus92 · 07-16-2020

Thanks a lot ! access-list 100 deny ip 10.0.10.0 0.0.0.255 192.168.50.0 0.0.0.255 access-list 100 permit ip any anyIt works 

Member Since	‎06-08-2019 02:50 PM
Date Last Visited	‎10-09-2026 06:44 AM
Posts	20
Total Helpful Votes Received	32

User Statistics

User Activity

FTD 7.6.4 – RPF neighbor not updated after PIM neighbor loss

Nexus Dashboard Insight - ACI

APIC Simulator in prod environment

ACI CIMC Upgrade

Automatic ready state after phone failure

Re: ACI CIMC Upgrade

Re: APIC Simulator in prod environment

Re: ACI CIMC Upgrade

Re: Site to site VPN not working

Re: Remote access VPN no LAN access