Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,I am migrating from MDS 9148S to MDS 9148T, I have included a part of Zoneset output below and I can see a unique fcid though, but same WWPN is listed under each zone, please can you explain the logic here.This output is from MDS9148S, I a...
I can see Active Zoneset with the command show zone status vsan or show zoneset active, the hosts are connected and there is FLOGI, but when I run the command “show zone alaysis vsan” I do not see any Zonesets listed, can I ignore, should I create a ...
MDS9396S was migrated to MDS9396T successfully, the zonesets are detected under Show zone status, but not under Show zone analaysys. copy zone or zone import commands are no more available, please advise.
I am migrating from 9396S to 9396T through ISL based migration, 9396S (OLD SWITCH) has Enhanced zone set with valid zones,Question is, I shall set Enhanced zone on 9396T, but the warning below is confusing, if I continue, doesn't the empty zoneset ge...
When I set a unique Domian ID on the new switch, create an ISL between the old and the new, why isn't the complete configuration such as zonesets, zone and fcalias copy over from old to new san switch? why do I have to manually create Fcalias/zones ...
I am migrating from 9396S to 9396T and this is an example, 9396S suppose has VSAN1 in enhanced zone with some valid zones, In the 9396T I shall create VSAN1 and change the zone type to Enhanced ? I believe this is expected, this has to be same for E ...
Thanks for your response Jason, I have created the high-level steps, please validate if they make sense, my understanding is with Enhanced VSAN the complete config including Zoneset and FCALIAS must flow from old switch to new. Confirm all active VSA...
