About pression2

pression2 · 02-06-2004

Hi everybody, I have a central site with one 506E Pix and 5 remote sites connected using 501E Pix (IpSec Tunnels). Now I have to permit VPN clients to connect to the central site (no problem for this) but also they have to be able to access the remot...

pression2 · 02-06-2004

Hi everybody,I have a central site with one 506E Pix and 5 remote sites connected using 501E Pix (IpSec Tunnels). Now I have to permit VPN clients to connect to the central site (no problem for this) but also they have to be able to access the remot...

pression2 · 11-12-2003

Hi everybody, I'm trying to open ports 25 smtp and 80 http so clients from the outside interface can access http mail and smtp of a server which is on the inside interface of the PIX.What I've implemented is...object-group service WATBC01 tcp descr...

pression2 · 06-25-2003

--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...

pression2 · 06-19-2003

Hello everybody,I've got a connecting two sites using PIX 506E and PIX 501. The one on central site (WATBCINX1 - PIX 506E) sends packet correctly and the one on remote site (CTXPOINX1 - PIX 501) receives them (checked out using debug icmp trace on bo...

pression2 · 02-24-2004

Hi blind,If you're using MS VPN client you've got another option. You just have to unmark the option "use the default gateway on the remote site" on (TCP/IP properties of the MS VPN Client). Once this option is unmarked, establish a connection to the...

pression2 · 02-12-2004

The 506E on central site is already configured to accept vpn connections. The problem is that it connects on the outside interface of the Pix and therefore it cannot use the already setup tunnels used by the remote sites. If you meant setting up seve...

pression2 · 11-12-2003

I found out what the problem was, I tried to telnet 10.0.0.5 on tcp port 80 from the outside router and I got the http server response, the access-list was working correctly.The problem was on the outside router that althought http traffic had been ...

pression2 · 06-22-2003

Thank you Mike-greene I forgot to assign the crypto map to match address in access-list 101. Now it works ok! I appreciate it!

Member Since	‎06-19-2003 11:39 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	9
Total Helpful Votes Received	5

User Statistics

User Activity

VPN clients being able to access already setup tunnels

Cisco VPN clients being able to access already setup tunnels

problems adding http and smtp on one access-list

How to avoid Ipsec VPN Tunnel from dropping down connetion?

PIX-TO-PIX VPN Tunnel using Ipsec. Need Help please.

Re: Can't access the internet after establishing VPN

Re: VPN clients being able to access already setup tunnels

Re: problems adding http and smtp on one access-list

Re: PIX-TO-PIX VPN Tunnel using Ipsec. Need Help please.