Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can someone advise me on what would be the better solution for the following:A Hub and spoke network, new sites are going to be joining the main hub with PPP T1's, I still have to keep my network (main hub) protected and everyone else behind the PIX,...
What would be the more efficient way to implement a back up solution for this:DS3 point-to-point with a t1 frame backupThey 2 different routers and both circuits terminate in the same remote router, routing protocol is EIGRP, any ideas are greatly ap...
Does anybody knows of a good method to aggregate 2 T1's over FR, the purpose will be to provide more bandwidth without using an IMUX, any help is greatly appreciated.
This is the issue: two 3640 routers bridged over a DS3 (45MB), hssi and atm interfaces, utilization on the interfaces never goes over 40-42 % and after performing large data transfer still never goes above 40-42% utilization. Does anybody have any id...
Thank you very much! would you suggest having all 4 serial interfaces on the same subnet? i.e Router A serial 1 and serial 2 on the same subnet as Router B serial 1 and 2 as well?
I know this post is a little old, did you implement this that you recommeded? is it working ok? I have the same setup with two 3640's hssi int and IRB across a DS3 but having problems with utilization.
