Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to install a Cisco RV110W router in to my network, currently I have a service contract with TalkTalk broadband, which uses PPOA to connect me to the internet. I was advised to put the router they provided in to bridge mode, which I have do...
Hi Chris,I've just done a hard reset on the CIsco and turned on and off the D-Link and set everything back up again, I got a connection then, through the Cisco! However it went back down again, but, just turned everything off, and then the d-link on,...
There seems to be a descrepency between the gateway defined for the WAN in the settings and the one in the Routing Table.. not sure if this is a problem or I'm interpreting the data incorrectly.I also noticed that when I was trying to get the connect...
Hi Christopher, thanks for a quick response, see results below:That should be all of the pings etc you asked for... Thanks - got another question too, but need to go offline to log in to the router for the screen shots.
Hi Christopher, Thank you for your help, it is very much appreciated.I seem to have made some progress following your instructions above, but I still cannot access the internet and I'm not sure why.I have attached some screen shots. One of the status...
