Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I am new in this forum , and I am having same issue. I have installed ME on a second hand AP2802i, exactly: AIR-AP2800-K9-ME-8-10-196-0.tar, after installation finish I have configured it. I am able to ping the management interface IP from my...
Thanks guys for your time. I want to fully understand even though I already have it working.PC Network configurationPhysical port: Static192.168.18.100255.255.255.0 WIFI: DHCP192.168.18.6255.255.255.0192.168.18.1Connection:PC to POE, POE to AP2800PC ...
Hi @Mark Elsen, I have done a factory reset one more time and I have configure it as below:Country AUNTP yesNTP server yesTimezone 28Management IP dhcpManagement scope noSSIDpsk pskRF yesDensity typicalVoice noFlex+Bridge no (Cisco Controller) >show ...
@Mark Elsen, I am noob using the CLI, Could you guide me which commands should I use please.Looking more information from other forums here, someone else was getting same issue, here is more details of my configuration:(Cisco Controller) >show inter...
