I would love to do the same, however I'm relying on the hairpin-NAT feature of NVI. I've heard that you can use traditional NAT and hairpin it using loopbacks and route-maps, but I've never seen the actual code.

Apparently the issue is related to me using DHCP from my ISP. So when the router reboots, whatever propagates the NAT table doesn't find an outside IP address assigned yet and--BUGGED. TAC was unable to come up with another solution. It doesn't look ...

I've been working with TAC for 2 days now. Still no luck. They said that NVI translation is only for VRF to VRF, not for use in global, so it's not supported that way. In other words, they won't look into the bug. So I put everything into VRFs, but n...

Everything works fine until I reload. The PAT overload continues to work fine (Internet access continues to work), however my static ports stop working and show up as standard nat rather than nvi nat in the show ip nat commands. If I retype the stati...

Any luck on this? I'm having the exact same issue on an 1841 with IOS 15.1 and almost the exact same configuration. Show ip nat trans shows the port-based NVIs at startup rather than under show ip nat nvi trans. That is until I manually renter them i...