About abolis

abolis · 05-22-2007

Hello, I'm in the process of closing a big hole my predecessor left for me. I maintain a small school district's network that also provides Internet access to our local police. The initial setup was this:Cisco 2800 Router (provided by ISP, non-conf...

abolis · 07-22-2006

Hello, all. I'm having difficulty setting up a VLAN to be on the same subnet as my ATM0.1 interface. I have static IPs provided by my ISP, the last one is the router, and I want the first one on my server. I recently upgraded my flash from 24M to ...

abolis · 05-29-2007

OK. I understand now that NAT translations happen after ACLs are passed. That still does not resolve the issue. If I type the public IP address of my webmail server (x.x.x.4) from my home computer (y.y.y.180), I get to my webmail server. If I att...

abolis · 07-22-2006

Thanks for your help. After adding the ip nat inside source item (already had the ACL from an earlier portion of the config), everything went swimmingly. I happen to not need the Dialer interface because I don't login (DSL provider/Phone company ow...

abolis · 07-22-2006

I'm going to try the "ip nat inside source list 1 int (BVI2) overload" command, I don't require a login to my DSL provider, but I will try the Dialer0 config as a last resort. I noticed the ip nat inside command in previous config files, but it ment...

abolis · 07-22-2006

No problem... As a note, I pulled out my VPN, DNS, DHCP, and NTP config...ip cefbridge irbinterface ATM0 no ip address no atm ilmi-keepalive dsl operating-mode autointerface ATM0.1 point-to-point no ip address no snmp trap link-status atm route-brid...

Member Since	‎07-22-2006 05:43 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	6

User Statistics

User Activity

PIX 515E not allowing NAT translations on local public subnet

877W Router, IRB, VLANs, ATM

Re: PIX 515E not allowing NAT translations on local public subne

Re: 877W Router, IRB, VLANs, ATM

Re: 877W Router, IRB, VLANs, ATM

Re: 877W Router, IRB, VLANs, ATM